On the British motoring show Top Gear, Richard Hammond drove a 1963 Kadett A through the middle of Botswana and across the Makgadikgadi Salt Pan. He loved the car so much that he named it Oliver and later had the car shipped to the United Kingdom and restored, and it remains in his possession. It appeared on Richard Hammond's Blast Lab with the personalised number plate 'OL1 V3R'. It also appeared in the Top Gear lorry challenge as one of the used obstacles.
The Opel Performance Center in 2011 launched a hardcore version of the Corsa OPC – Corsa OPC Nürburgring Edition. The engine is the same, 1.6 litre turbo, but it has been tuned to punch out 210 PS (154 kW; 207 hp) and 250 Nm (280 Nm with overboost function) of torque at 2,250 to 5,850 rpm. 0–100 km/h time is 6.8 seconds and top speed is 230 km/h (143 mph).
The Kadett E (Vauxhall Astra Mark 2 in the UK) wis introduced in 1984, an wis votit 1985 European Caur o the Year, lairgely due tae its advanced aerodynamic body stylin. The 1984 model wis an aa developt intae a mair conventional three-box design wi a buit (trunk), badged as the Vauxhall Belmont in the UK an the Opel Monza in Sooth Africae, launcht in Januar 1986. This wis awardit 1985 Semperit Erse Caur o the Year in Ireland.
Still, a number of Kadetts has been captured as trophies by the Red Army and available for study and reverse-engineering. This project was conducted by design bureaus formed as Soviet-German joint ventures under the Soviet Military Administration in Germany (SMAD). There were 11 of them in total. One in Berlin (reverse-engineered the engine and transmission. Another in Schwarzenberg worked on the steel body. The wooden-bodied station wagon was developed in Chemnitz. The vast majority of the personnel of these design bureaus were German specialists and craftsmen hired by the Military Administration. These design bureaus not only prepared the necessary blueprints and documentation, but also provided the wooden master model for the body. They even developed the new trim pieces which distinguished the Moskvitch from its Opel prototype, including hood emblems and hubcaps with a large "M" (for "Moskvitch"). However, the stamping dies and most of the tooling had to be produced in the USSR.
It had some crazy mechanical issues. At one point it stumbled and stalled because the carburetor had come loose from the intake manifold and I had to tighten it back down! Another time, my brother was driving it and the brakes failed. Somehow the end of the brake shoe that meets the brake cylinder piston had become worn on one side, causing the piston to slip off the end of the shoe when the brakes were applied, losing braking and squirting fluid all over.